Residential Roofer in Charlotte, NC

Two pipe flashings on this shingle roof were showing signs of failure, leaving the attic below open to leaks. The crew removed the worn flashings and installed new pipe boots to industry standards and manufacturer guidelines. Photos show the attic…

An improperly installed valley was letting water work under the shingles. The crew stripped shingles two feet on each side, laid a three-foot ice and water shield liner, and rebuilt the valley with new starter, matching shingles, and ridge cap…

Several new plumbing pipes on this asphalt shingle roof needed proper flashing, and the gutters needed guards to keep debris out. The crew cut each opening and installed five new pipe flashings to manufacturer guidelines, then fitted gutter guards along…

Scattered spots on this shingle roof were letting water through, with the work centered on the vent pipe penetrations. The crew repaired each area from ladders and on the roof, working around the vent pipes and nearby shingles. Photos show…

A pipe boot had failed, a corner flashing was open, and 4 SF of shingles were damaged. The pipe flashings and the open corner were repaired, and the damaged shingles were replaced. The job record also lists nail pops and…

Loose coping at the wall was letting water in at that edge. The crew re-secured the coping and sealed it with NP-1 for a tight finish.Photos show the sealed metal at the shingles and the roof detail around a nearby…

Nails were backing out where the substrate had softened. The crew repaired the rotten substrate and replaced the shingles in that area with new ones and the right size fasteners. Photos show the roof elevation before the work, then sealed…

A roof leak traced to a vent penetration on the third floor. The crew opened the shingles around the vent, set a new black box vent, and sealed it into the courses. Photos show the stained attic underside at the…

A three-story leak pointed to the box vent area on the roof. The crew opened the roof around the vent, sealed the vent into new shingles, and finished the courses along the wall trim.Photos show the opened deck, the sealed…

A nail pop and damaged wood showed up at the dormer roof-to-wall. The crew opened the roof at the brick, patched the deck, installed new wall flashing, and put the shingles back.Photos show the open deck, the plywood patch, the…

Found squirrel damage to the gutter guard at a roof corner, where chewing had opened a hole and left the gutter exposed. Fitted new metal covering over the damaged section and fastened it along the eave to close the opening.…

The flashing at the pipe penetration had failed, with the boot collar deteriorated where it met the pipe. A new pipe boot was installed over the penetration, set into the shingle courses and sealed at the collar. The job record…

The gutter above the courtyard was dripping, with the trough holding accumulated leaves, grit and debris along its run. Sealant was worked into the joints from inside the trough and along the corner where the gutter meets the roof edge.…

Nail pops and rusted fasteners were found scattered across the front and rear slopes, alongside the pipe boots flagged for replacement. Each raised fastener was sealed at the shingle face, tabs were lifted and sealed beneath, and ice and water…

Wall flashing at the corner had failed, leaving the deck and trim rotten and leaking. The gutter was detached and reset, corner trim cut up and siding pulled back, then the rotten plywood and roofing were removed and replaced with…

A mini split unit was removed from the roof, leaving an open hole through the membrane at its former location. The opening was patched and sealed flush with the surrounding membrane, with mastic worked out around the full perimeter of…

Soffit vents were missing along the roof edge, leaving the openings open. Nine vents were replaced, in addition to ten replaced on an earlier visit. The job record does not list the work completed, and the photos show the open…

Replaced ten missing soffit vents on a residential building where the openings had been left uncovered at the eaves. Fitted new louvered vents into each opening along the soffit and fastened them in place, restoring closed and screened coverage at…

Deterioration had set in along the wall termination, with the membrane lifting to reveal heavy rust on the metal beneath. Twenty-five linear feet of termination bar were removed, the area was cleaned, and new termination bar was installed and sealed…

Holes had opened in the membrane where the surface took physical damage, with the material torn back and the layers beneath exposed. The damaged area was repaired and sealed across the opening, tying the patch into the surrounding membrane at…

Two damaged skylights were allowing water to penetrate, and the surrounding shingles were removed to open the area. Both skylights were replaced with new units, then new underlayment and matching shingles were installed around the curbs and step flashing. The…

Identified open coping joints and degraded sealant at rooftop penetrations on a residential parapet wall. Cleaned and secured four open coping joints and sealed them against water infiltration, then cut out failed caulking at five penetrations, cleaned each area, and…

Completed scattered repairs at several isolated failure points on a residential roof. Replaced damaged metal flashing at the eave where the decking had deteriorated, resealed the shingle courses at the drip edge, and ran new sealant along the roof-to-wall flashing…

The existing dryer vents and pipe collar were removed, leaving the deck openings and flex duct exposed at each location. Two new dryer vents and one new pipe collar were set over the openings, flashed into the surrounding shingle courses.…